Monday, August 16, 2021

Another EBT car and Starting Portland Locomotive Works RPO

While I am still working on painting several of the kits that I built over the summer, I recently started a kit that I have long been putting off. Not exactly sure how I decided to start this kit, regardless, I did and managed to get it finished without the expected major difficulty.

A few years ago, I picked up some PSC EBT hopper car kits for a friend that was looking to pass them on to another Eastern narrow gauge modeler. At the time, I was very concerned about the heat flow through the pieces and that what I had soldered would come un-soldered as I worked on other portions of car. 



I used a standard, large soldering iron tip for the majority of the model. Interestingly the large tip put a lot of heat in the think metal exactly where I needed it, without having it transfer to other areas. This worked so well, that I even used the large tip for most smaller details. I did use a small round tip for some of the brake details and twice used a resistance soldering unit. I'm guessing this worked well due to the small size of the parts and the thinness of the the brass sheet parts?

The most difficult parts were the steps for the brake wheel and the supporting brakes. I may redo these at some point. The car is essentially finished except for more cleaning of overdone soldering joints. I'm going to take a breather before the finishing touches. 



I think the car came out fairly well; however, I would say for the price, the pain and the time, the Bachmann On30 cars convert to On3 MUCH more easily!

This weekend, I started the Portland Locomotive Works WW&F RPO. The assemble has gone VERY quickly, as it is so similar to the passenger car kits that they produce. Waiting for the paint to dry for the next coat, then the gloss coat. The roof needs the trim over the doors that prevents water running down. More soon.........





No comments:

Post a Comment